Explorer 2WD V8-4.6L VIN 8 (2006)
12. Allow the fluid to drain. When the fluid comes out as a thin stream or drip, the fluid is at the correct level.
13. Reinstall the small (center) fluid level indicating plug.
^
Tighten to 10 Nm (89 inch lbs.).
Transmission Fluid Cooler - Backflushing and Cleaning
Transmission Fluid Cooler - Backflushing and Cleaning
Material
Material
CAUTION: Whenever a transmission has been disassembled to install new parts or a new or remanufactured transmission has been installed, a new
transmission fluid cooler, either in-tank, auxiliary or oil to air (OTA), if equipped will need to be installed. Using a suitable torque converter/fluid
cooler cleaner, clean and backflush the transmission fluid cooler tubes.
CAUTION: Use only clean automatic transmission fluid specified for this transmission. Do not use supplemental fluid additives, treatments or
cleaning agent. The use of these materials may affect transmission operation and result in internal damage to the transmission.
When internal wear or damage has occurred in the transmission, metal particles, clutch plate material or band material may have been carried into the
transmission fluid cooler. These contaminants are a major cause of recurring transmission concerns and must be removed from the system before the
transmission is put back in use.
NOTE: Do not use any solvents while carrying out this procedure. Only use clean automatic transmission fluid.
1. Conduct backflushing with a suitable torque converter/transmission fluid cooler cleaner. Test the equipment to make sure that a vigorous fluid
flow is present before proceeding. Install a new system filter if flow is weak or contaminated.
