Explorer 2WD V8-4.6L VIN 8 (2006)
Shift Cable: Adjustments
5R55S Selector Lever Cable Adjustment
Selector Lever Cable Adjustment - 5R55S
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Place the range selector lever in the first position all the way toward the rear of the vehicle.
3. Move the range selector lever forward 3 detents. This should be the (D) position.
4. Remove the cable shield by prying on the side of the shield closest to the boot, then sliding the shield away from the boot.
5. Disconnect the range selector lever cable end from the manual lever.
6. Rotate the manual lever clockwise until the travel stops. Then rotate the manual lever counterclockwise 3 detents, this should be the (D) position.