Explorer 2WD V8-4.6L VIN 8 (2006)
Special Tools
Special Tool(s)
Material
Material
CAUTION: Whenever a transmission has been disassembled to install new parts or a new or remanufactured transmission has been installed, a new
transmission fluid cooler (either in-tank, auxiliary or OTA) if equipped, will need to be installed. Using a suitable torque converter/fluid cooler
cleaner, clean and backflush the transmission fluid cooler tubes.
CAUTION: Use only clean automatic transmission fluid specified for this transmission. Do not use supplemental fluid additives, treatments or
cleaning agents. The use of these materials may affect transmission operation and result in internal damage to the transmission.
CAUTION: When internal wear or damage has occurred in the transmission, metal particles, clutch plate material or band material may have been
carried into the transmission fluid cooler. These contaminants are a major cause of recurring transmission concerns and must be removed from the
system before the transmission is put back into use.
When evidence of transmission fluid contamination (such as metal particles, clutch plate material or band material) is found in the cooling system, the
transmission fluid cooler flow test should be carried out.
If the transmission cooling system fails the transmission fluid cooler flow test, install a new transmission fluid cooler and flush out the fluid cooler
lines. If installing a new transmission fluid cooler, use only factory approved components.
NOTE: The engine idle, transmission linkage/cable adjustment, fluid level and line pressure must be within specification before carrying out this test.
1. Place the transmission range selector lever into PARK.
2. Raise the vehicle on a hoist and place suitable safety stands under the vehicle.
3. Hold the large drain plug with a wrench, and remove the small (center) fluid level indicating plug using a 3/16-inch Allen key.