Explorer 4WD V6-4.0L (2009)
Rear Bumper Cover / Fascia: Removal and Replacement
Bumper Cover - Rear, Explorer
Removal and Installation
1. Remove the tail lamp assemblies.
2. Remove the 2 rear bumper cover bracket bolts.
-
To install, tighten to 11 Nm (97 lb-in).
3. Remove the 9 bumper cover pin-type retainers.
4. Disconnect the rear parking aid sensor electrical connector, if equipped.
5. NOTICE: To avoid damaging the rear bumper cover, do not twist the cover when removing.
Remove the bumper cover.
-
Lift the outer corners upward and pull the bumper cover straight up and out.
6. Transfer components as necessary.
7. To install, reverse the removal procedure.