Explorer 4WD V6-4.0L (2009)
If not welded to the muffler inlet pipe, make sure that the service exhaust coupler is against the alignment nub and is positioned approximately at
the 2 o'clock position facing the muffler. If the muffler inlet pipe does not have an alignment nub, center the exhaust coupler over the muffler inlet
pipe joint and position it at approximately the 2 o'clock position facing the muffler.
-
Tighten to 47 Nm (35 lb-ft).
All Vehicles
7. NOTE: Install new exhaust Y-pipe dual catalytic converter-to-muffler assembly gasket and nuts.
Install the exhaust Y-pipe-dual catalytic converter-to-muffler assembly new gasket, 2 bolts and 2 new nuts.
-
Tighten to 40 Nm (30 lb-ft).
8. Check to see if the exhaust system isolators are at zero load. If the exhaust system isolators are not at zero load, then carry out the exhaust system
alignment procedure. For additional information, refer the Exhaust System Alignment See: Service and Repair/Exhaust System Alignment.