Explorer 4WD V6-4.0L (2009)
Information Bus: Pinpoint Tests
Pinpoint Test A: The PCM Does Not Respond To The Scan Tool
Communications Network
Pinpoint Tests
Pinpoint Test A: The PCM Does Not Respond To The Scan Tool
Refer to Wiring Diagram Set 14, Module Communications Network for schematic and connector information. See: Diagrams/Electrical
Diagrams/Diagrams By Number
Refer to Wiring Diagram Set 23, Electronic Engine Controls - 4.0L for schematic and connector information. See: Diagrams/Electrical
Diagrams/Diagrams By Number
Refer to Wiring Diagram Set 24, Electronic Engine Controls - 4.6L for schematic and connector information. See: Diagrams/Electrical
Diagrams/Diagrams By Number
Normal Operation
The PCM communicates with the scan tool through the High Speed Controller Area Network (HS-CAN). Circuits VDB04 (WH/BU) (HS-CAN +) and
VDB05 (WH) (HS-CAN -) provide the network connection to the PCM.
This pinpoint test is intended to diagnose the following:
-
Wiring, terminals or connectors
-
PCM
PINPOINT TEST A: THE PCM DOES NOT RESPOND TO THE SCAN TOOL
NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the
connector.
NOTE: Failure to disconnect the battery when instructed will result in false resistance readings. Refer to Battery.
-------------------------------------------------
A1 VERIFY WHETHER OTHER HS-CAN MODULES PASS THE NETWORK TEST
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
In the left hand pane of the Integrated Diagnostic System (IDS) network test display screen, verify whether any HS-CAN modules passed the
network test.
-
Is the text "pass" or a DTC listed next to any of the following modules (if equipped): 4x4 control module, ABS module, Accessory
Protocol Interface Module (APIM), Instrument Cluster (IC), Occupant Classification System Module (OCSM), PCM or Restraints
Control Module (RCM)?
Yes
If "pass" or a DTC was listed next to the PCM, a network fault is not currently present. Go To Pinpoint Test T to diagnose an intermittent HS-CAN fault
condition. See: Pinpoint Test T: Intermittent No High Speed Controller Area Network (HS-CAN) Communication, One Or More Modules Are Not
Respond
If "pass" or a DTC was listed next to one or more modules other than the PCM, GO to A2.
No
No modules are currently communicating on the HS-CAN. Go To Pinpoint Test s to diagnose no HS-CAN communication. See: Pinpoint Test S: No
High Speed Controller Area Network (HS-CAN) Communication, All Modules Are Not Responding
-------------------------------------------------
A2 COMPUTERS AND CONTROL SYSTEMS INFORMATION PINPOINT TEST QA VERIFICATION CHECK
-
Verify that pinpoint test QA has been performed.
-
Has pinpoint test QA been performed?