Explorer 4WD V6-4.0L (2009)
-
Disconnect: SJB Fuse 17 (10A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. GO to T9.
No
INSTALL the removed fuse. GO to T10.
-------------------------------------------------
T9 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE RCM DISCONNECTED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: RCM C310b.
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
CONNECT the RCM. Go To Pinpoint Test D. See: Pinpoint Test D: The Restraints Control Module (RCM) Does Not Respond To The Scan Tool
No
CONNECT the RCM. Go To Pinpoint Test F. See: Pinpoint Test F: The Occupant Classification System Module (OCSM) Does Not Respond To The
Scan Tool
-------------------------------------------------
T10 VERIFY VEHICLE EQUIPMENT - TCM
-
A TCM is present in 6R60 transmission equipped vehicles only. Inspect the vehicle for a 6R60 transmission.
-
Is the vehicle equipped with a 6R60 transmission?
Yes
GO to T11.
No
GO to T12.
-------------------------------------------------
T11 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE TCM DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: BJB Fuse 27 (20A) and SJB Fuse 9 (2A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuses. Go To Pinpoint Test B. See: Pinpoint Test B: The Transmission Control Module (TCM) Does Not Respond To The Scan
Tool
No
