Explorer 4WD V6-4.0L (2009)
7. Verify the rubber adapter is in place.
8. Coat the thermal bypass valve with petroleum jelly to hold it in place and install the thermal bypass valve in the transmission case.
9. NOTICE: Do not touch the electrical connector pins or the exposed solenoid tabs on the transmission vehicle harness connector.
Electrostatic discharge may occur and may cause damage to the mechatronic unit.
Position the mechatronic assembly in place and loosely install the 11 bolts.
1. Align the manual valve and control lever linkage.
10. Tighten the mechatronic bolts in the sequence shown.
-
Tighten to 8 Nm (71 lb-in).
11. NOTICE: Do not touch the electrical connector pins. Electrostatic discharge may occur and will cause damage to the mechatronic unit.
