Explorer 4WD V6-4.0L (2009)
4. NOTICE: Do not use a hammer to separate the rear axle halfshaft assembly from the hub. Damage to the threads and internal Constant
Velocity (CV) joint components may result.
Using the Front Wheel Hub Remover, press the outboard CV joint until it is loose in the hub.
5. Remove the brake cable retainer screw.
-
To install, tighten to 20 Nm (177 lb-in).
6. Remove and discard the outboard toe link nut and back out the bolt for clearance.
-
To install, tighten to 350 Nm (259 lb-ft) at curb ride height.
7. Remove and discard the lower arm outboard bolt.
-
To install, tighten to 275 Nm (203 lb-ft) at curb ride height.
8. Remove and discard the 3 wheel knuckle bolts.
-
To install, tighten to 275 Nm (203 lb-ft).
9. Pivot the wheel knuckle assembly upward on the upper arm outboard bolt.
-
Loosen the upper arm bolt to prevent bushing damage.
-
To install, tighten to 275 Nm (203 lb-ft) at curb ride height.