Explorer 4WD V6-4.0L (2009)
![background image](/ford/explorer_4wd/v6-4.0l/Page-1503009.png)
7. For the inboard CV joint, carry out the following:
1. Pack the inboard CV joint housing with 250 g (8.82 oz) of grease.
2. Spread any remaining grease evenly inside the boot and CV joint.
3. Install the inboard CV joint housing, seating the boot in the groove in the housing.
8. Set the halfshaft assembled length to specifications. For additional information, refer to Specifications.
1. Measure the entire assembly length.
2. Push in or pull out on the inner joint as necessary to adjust the halfshaft assembled length.
3. Hold the inner joint to prevent the assembled length from changing, and insert a soft, flat tool between the boot and the joint to equalize the
pressure.
9. Using the Constant Velocity Joint Boot Clamp Installer, install both boot clamps.
10. Install the halfshaft assembly. For additional information, refer to Halfshaft See: Removal and Replacement/Rear Drive Halfshafts.