Explorer 4WD V6-4.0L VIN E (1999)
8. Remove the front band locknut and unscrew the front band adjusting screw.
-
Discard the front band locknut after removal.
9. CAUTION: Servo cover is under spring pressure.
Using Servo Cover Compressor, remove the front band servo cover retaining ring.
1
Install the Servo Cover Compressor and compress the front band servo cover.
2
Remove the front servo cover retaining ring.
-
Slowly remove tension on the J-hook nut and remove the servo cover compressor.
10. CAUTION: Servo removal tool should be used to prevent damage to servo and bore.
Use Servo Removal Tool to remove the front band servo cover, servo piston and servo piston spring.
-
Insert Servo Removal Tool into the transmission case, locate on servo rod, and remove front band servo cover, servo piston and servo piston
spring.
Installation