Explorer 4WD V6-4.0L VIN E (1999)
8. NOTE: Offset the Gauge Block to obtain an accurate reading.
Rotate the Gauge Block several half-turns to make sure of correct seating of the pinion bearings and position the Gauge Block.
9. Install the special tool.
1
Position the special tool.
2
Install the bearing caps.
3
Install the four bolts.
10. NOTE: Use only flat, clean drive pinion bearing adjustment shims.
NOTE: Selection of too thick a pinion shim results in a deep tooth contact at final assembly of integral rear axle assemblies. Do not attempt to
force the pinion shim between the Gauge Block and the Gauge Tube. A slight drag indicates correct shim selection.
Use a drive pinion bearing adjustment shim as a gauge for shim selection.
-
Check the pinion bearing adjustment shim thickness between the Gauge Block and the Gauge Tube.
-
After determining the correct shim thickness, remove the special tools.
