Explorer 4WD V8-302 5.0L VIN P SFI (2000)
Keyless Entry Key-Pad: Service and Repair
Programming
Programming your own personal entry code
1. Enter the factory-set code (keypad will illuminate when pressed).
2. Press the 1-2 control within five seconds of step 1.
3. Enter your personal five digit code. Enter each digit within five seconds of the previous one.
NOTE: Do not use a code that includes five of the same number presets in sequential order. Thieves can easily figure out these types of codes.
Your personal code does not replace the permanent code the the dealership gave you. You can use either code to unlock your vehicle. If a second
personal code is entered, the module will erase the first personal code in favor of the new code.
If you wish to erase your personal code, use the following instructions:
Erasing your personal code
1. Enter the factory set code.
2. Press 1-2 within five seconds of step 1.
3. Press the 7-8 and 9-0 controls at the same time within five seconds of step 2.
The system will now only respond to the factory-set code.