Explorer 4WD V8-302 5.0L VIN P SFI (2000)
5. Remove the speed control servo.
INSTALLATION
1. Install the speed control servo bracket bolt.
2. Insert the speed control cable slug into the speed control servo pulley slot.
1
Gently compress the speed control servo spring.
2
Insert the speed control cable slug into the speed control servo pulley slot.
3. Release the compressed spring while aligning the speed control actuator cable cap tabs with the slots in the speed control servo housing.
WARNING: INCORRECT WRAPPING OF THE SPEED CONTROL ACTUATOR CABLE AROUND THE SPEED CONTROL
SERVO PULLEY MAY RESULT IN A HIGH IDLE CONDITION.
NOTE: Make sure the rubber seal is fully seated onto the speed control actuator cable cap.