Explorer 4WD V8-302 5.0L VIN P SFI (2000)
Crankshaft Main Bearing Seal: Service and Repair
Special Tools
Removal
1. Remove the flywheel.
2. CAUTION: Avoid scratching or damaging the oil seal surfaces during removal of the crankshaft rear oil seal.
Note: Be sure the crankshaft rear sealing surface is clean and free of any rust or corrosion. To clean the crankshaft rear sealing surface, use
extra-fine emery cloth or extra-fine 0000 steel wool with Metal Surface Cleaner F4AZ-19A536-RA or equivalent meeting Ford specification
WSE-MSB392-A.
Use Rear Crankshaft Seal Remover and Impact Slide Hammer to remove the crankshaft rear main seal.
Installation