Explorer 4WD V8-302 5.0L VIN P SFI (2000)
16. Laying the seat on its other side, remove the retaining bolt for the seat pivot, being careful not to damage the seat pivot, cable or any of the wires.
CAUTION: When positioning the seat or separating the seat bottom from the back, be careful not to damage the seat back pivot and any of the
wires or cables from the seat back to the seat bottom. This can cause damage to one of the seat components.
17. Remove the seat back from the seat bottom.
1
Pull the heated seat wire harness through the seat bottom.
2
Pull the lumbar support cable through the seat bottom.
3
Pull the side air bag module wire harness through the seat bottom.
4
Remove the seat back from the seat bottom.
18. Separate the seat back trim cover lower J-clip.
19. Remove and discard the hog rings from the two swing rods (one shown).
