Explorer 4WD V8-302 5.0L VIN P SFI (2000)
1. Install (A) Synchro Positioning Tool, aligning tabs and notches with those on the (B) camshaft synchronizer.
2. Install the camshaft synchronizer.
NOTE:
^
When installing the camshaft synchronizer into the cylinder block, make sure that the arrow on special tool is pointing toward the front of the
vehicle, on a line that is parallel to the center line of the crankshaft.
^
The synchronizer will rotate slightly as the synchronizer gear engages the camshaft gear. When the synchronizer is fully installed the arrow on
the special tool should point to the position of the electrical connector.
3. Position the clamp and install the bolt.
4. Remove the special tool.
5. Install the CMP sensor.
