Explorer 4WD V8-302 5.0L VIN P SFI (2000)
3. Install the tie rod end castellated nut.
1
Position the tie rod end.
2
Install the tie rod end castellated nut.
3
Install a new cotter pin.
4. CAUTION: The torsion bar adjustment bolt is coated with dry adhesive and must be replaced if it is backed off or removed. Failure to do so can
cause the adjustment bolt to loosen up during operation and a loss of vehicle alignment.
Preload the torsion bar.
1
Tighten the torsion bar tool until the new adjustment bolt and nut can be installed.
2
Turn the adjustment bolt until preliminary adjustment marks are aligned.
5. Remove the torsion bar tool and adapters.
6. Install the torsion bar cover plate.
1
Position the torsion bar cover plate.
2
Install the retaining bolts.
7. Install the wheel hub.