Explorer 4WD V8-302 5.0L VIN P SFI (2000)
2. Position the boot clamps on the outboard halfshaft boot.
3. Note: Tighten the through-bolt until the installer is in the closed position.
Use the CV Boot Clamp Installer to install the outboard CV joint boot clamps.
4. Position the boot clamp on the halfshaft.
5. Position the inboard halfshaft boot.
6. Install the CV joint on the halfshaft.
1. Line up the marks on the halfshaft and the CV joint.
2. Install the CV joint on the halfshaft.
