Explorer 4WD V8-4.6L (2008)
Third Row Seat Cushion (Part 2)
Removal and Installation
1. Fold the backrest not being serviced down.
2. Release the backrest trim cover J-clip at the top of the trim cover by the head restraint.
-
Pull the head restraint release strap through the backrest trim cover.
3. Remove the 2 head restraint-to-backrest frame bolts and remove the head restraint.
-
To install, tighten to 25 Nm (18 lb-ft).
4. Remove 2 bolts and the hinge cover.
5. Remove 2 bolts and the latch cover.
6. Release the backrest trim cover lower J-clip.
7. CAUTION: Use care when separating the seat back trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn
from the backrest foam pad.
Release the backrest trim cover side J-clips, hook-and-loop strips, invert and remove the backrest trim cover.
8. To install, reverse the removal procedure.
Seat Cushion Cover - Third Row
SEAT CUSHION COVER - THIRD ROW
Exploded View
