Explorer 4WD V8-4.6L (2008)
![background image](/ford/explorer_4wd/v8-4.6l/Page-696003.png)
Removal
1. Remove the oil pan.
2. Remove the bolts and the oil pump screen and pickup tube.
Installation
1. CAUTION: Make sure the O-ring seal is in place and not damaged. A missing or damaged O-ring seal can cause foam in the lubrication
system, low oil pressure and severe engine damage.
NOTE: Clean and inspect the mating surfaces and install a new O-ring seal. Lubricate the O-ring seal with clean engine oil prior to installation.
Position the oil pump screen and pickup tube and install the bolts.
^
Tighten the oil pump screen and pickup tube-to-oil pump bolts to 10 Nm (89 lb-in).
^
Tighten the oil pump screen and pickup tube-to-spacer bolt to 25 Nm (18 lb-ft).