Explorer 4WD V8-4.6L (2008)
Communications Control Module: Service and Repair
AUDIO CONTROL MODULE (ACM)
Removal and Installation
NOTE:
-
When installing a new navigation audio control module (ACM), remove the navigation DVD before sending the ACM to an authorized audio
system repair facility.
-
It is not necessary to remove the ACM to retrieve the part number.
1. NOTE: Module configuration is only required if a new ACM is being installed.
Upload the ACM configuration information to the scan tool. Refer to Information Bus (Module Configuration) to carry out programmable module
installation (PMI). See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and
Relearning
2. Remove the instrument panel center finish panel.
3. Remove the 4 screws and the ACM.
-
Disconnect the ACM electrical connectors and the antenna lead-in cable(s).
4. To install, reverse the removal procedure.
-
Download the configuration information to the ACM.
