Explorer 4WD V8-4.6L (2008)
Parking Assist Control Module: Service and Repair
PARKING AID MODULE
Removal and Installation
1. Disconnect the parking aid module (PAM) bumper harness from the body harness.
2. Remove the rear bumper cover.
3. Remove the 4 insulator-to-bumper cover nuts and the insulator from the bumper cover.
4. Disconnect the PAM bumper harness from the PAM.
5. Remove the 2 PAM bracket bolts.
6. Remove the parking module bracket assembly.
7. Release the module tabs from the bracket and remove the module.
8. To install, reverse the removal procedure.
