Explorer 4WD V8-4.6L (2008)
4. Disconnect the battery cable electrical connector.
5. Remove the 2 battery cable locators from the battery tray.
6. Remove the battery junction box (BJB) terminal nuts.
-
To install, tighten to 9 Nm (80 lb-in).
7. Position the generator harness terminal aside.
8. Position the BJB terminal aside.
9. Remove the 2 nuts and position the battery cable bracket aside.
-
To install, tighten to 20 Nm (15 lb-ft).
10. Remove the nut and position the power steering (P/S) line bracket aside.
-
To install, tighten to 12 Nm (9 lb-ft).
11. Remove the nut and position the battery cable engine front cover bracket aside.
-
To install, tighten to 10 Nm (89 lb-in).
12. Disconnect the A/C compressor electrical connector.
13. Remove the A/C compressor electrical connector harness locator.
14. Remove the bolt and position the battery cable right engine mount bracket aside.
-
To install, tighten to 20 Nm (15 lb-ft).
15. Remove the starter solenoid terminals protective cap.
16. Remove the nut and position the starter solenoid positive cable terminal aside.
-
To install, tighten to 12 Nm (9 lb-ft).
17. Remove the nut and position the starter solenoid wire cable terminal aside.
-
To install, tighten to 6 Nm (53 lb-in).
18. Remove the nut and position the battery cable engine ground terminal aside.
-
To install, tighten to 25 Nm (18 lb-ft).
19. Remove the battery cable.
20. To install, reverse the removal procedure.