Explorer 4WD V8-4.6L (2008)
4. Position the manual lever and park rod in place.
^
Push down on the park pawl and position the park rod in place.
5. While holding the park rod down, install the park pawl abutment.
^
Tighten to 10 Nm (89 lb-inch).
6. NOTE: Before installing the mechatronic assembly into the transmission case, verify presence and correct orientation of the thermal bypass valve,
pump adapter seal and center support seals. Also note that one or more of the center support seals may have remained in the mechatronic assembly
during removal and should be installed into the transmission case at this time.
Verify the 4 rubber feed tubes for the center support are in place.
1
Black feed tube.
2
Green feed tube.
3
Blue feed tube.