Explorer 4WD V8-4.6L VIN W (2002)
6. Remove and discard the slippers.
^
Clean the slipper mating surface.
7. CAUTION: Use a hub-mount brake lathe, if necessary, to machine the rear brake disc.
NOTE: Resurface the rear brake disc if a test drive has identified vibration transmitted through the steering wheel, seat, or brake pedal while
braking. Heavily scored brake discs (caused by worn brake pads), require resurfacing also.
Measure the rear brake disc, and resurface as necessary. Install a new rear brake disc if beyond specification.
Installation
1. CAUTION: Installation of new slippers is mandatory with service brake pad installation, even if the slippers appear undamaged. Make sure the
slippers are correctly positioned with the slipper ends snug against the outboard end of the anchor plate rail.
Clean the slipper mating surface. Apply 0.03g of Silicone Gasket and Sealant F7AZ-19554-EA or equivalent meeting Ford specification
WSE-M4G323-A4 to the slipper mating surface. Install the new slippers.