Explorer 4WD V8-4.6L VIN W (2002)
3. Position the driver air bag module to the steering wheel.
Vehicles built up to 03/2002
27. NOTE: Make sure the negative battery cable is still disconnected before continuing with the installation portion of this procedure.
Remove the restraint system diagnostic tool from the clockspring electrical connector at the top of the steering column.
28. Position the driver air bag module to the steering wheel.
1. Connect the driver air bag module electrical connector.
2. Slide and engage the driver air bag module electrical connector locking clip.
3. Connect the horn switch electrical connector.
4. Position the driver air bag module to the steering wheel.
All vehicles
29. Install the two driver air bag module bolts (one shown).
30. Install the two steering wheel back cover plugs (one shown).