Explorer 4WD V8-4.6L VIN W (2002)
![background image](/ford/explorer_4wd/v8-4.6l_vin_w/Page-2836005.png)
17. Using a suitable ball joint remover tool, remove the ball joint.
18. CAUTION: Do not damage the ball joint boot when installing the special tool.
NOTE: Apply a thin coat of silicone sealant to the wheel hub mounting surfaces before installation.
NOTE: Clean and inspect the control arm ball joint bore for damage before installing a new ball joint.
NOTE: Make sure the new ball joint snap ring is fully seated.
To install, reverse the removal procedure.
-
Always install new castellated nuts and cotter pins.