Explorer AWD V6-4.0L VIN K Flex Fuel (2003)
-
Clean the inside of the glass surface with an alcohol-free cleaner making sure the ceramic-coated area is clean.
-
Wipe off glass prep immediately after each application.
Apply glass prep meeting Ford specification WSB-M2G314-B twice around the glass surface.
5. Apply glass primer meeting Ford specification WSB-M5B280-C to the same area that was prepped in the previous step. Allow five minutes to
dry.
6. Cut the urethane applicator tip to specification.
7. Apply a bead of urethane adhesive meeting Ford specification WSB-M2G316-B to the pinch weld just outside the foam dam.
8. Install the windshield by aligning it to the marks previously made.
9. After the windshield glass has set, check for water leaks and add urethane where needed.
Item 1: Windshield Glass Moulding Assembly Installation Note
1. Install glass moulding prior to glass installation.
