Explorer AWD V8-4.6L (2010)
-
Wiring, terminals or connectors
-
ABS module
PINPOINT TEST C: THE ABS MODULE DOES NOT RESPOND TO THE SCAN TOOL
NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the
connector.
NOTE: Failure to disconnect the battery when instructed will result in false resistance readings. Refer to Battery.
-------------------------------------------------
C1 CHECK THE ABS VOLTAGE SUPPLY CIRCUITS FOR AN OPEN
-
Ignition OFF.
-
Disconnect: ABS Module C155.
-
Ignition ON.
-
Measure the voltage between the ABS module, harness side and ground as follows:
-
Are the voltages greater than 10 volts?
Yes
GO to C2.
No
VERIFY the Battery Junction Box (BJB) fuse 6 (40A) or fuse 33 (30A) and the Smart Junction Box (SJB) fuse 18 (10A) is OK. If OK, REPAIR the
circuit in question. If not OK, REFER to the Wiring Diagrams to identify the possible causes of the circuit short. CLEAR the DTCs. REPEAT the
network test with the scan tool. See: Diagrams/Electrical Diagrams/Diagrams By Number
-------------------------------------------------
C2 CHECK THE ABS GROUND CIRCUIT FOR AN OPEN
-
Ignition OFF.
-
Disconnect: Negative Battery Cable.
-
Measure the resistance between the ABS module C155-16, circuit GD120 (BK/GN), harness side and ground.
-
Is the resistance less than 5 ohms?
Yes