Explorer AWD V8-4.6L (2010)
-
Are the resistances greater than 1,000 ohms?
Yes
GO to U4.
No
GO to U19.
-------------------------------------------------
U4 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO VOLTAGE
-
Connect: Negative Battery Cable.
-
Ignition ON.
-
Measure the voltage between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.
-
Are the voltages greater than 6 volts?
Yes
REPAIR the circuit in question. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The CAN has tested within specifications. GO to Pinpoint Test T to diagnose an intermittent HS-CAN fault. See: Pinpoint Test T: Intermittent No High
Speed Controller Area Network (HS-CAN) Communication, One Or More Modules Are Not Respond
-------------------------------------------------
U5 CHECK THE HS-CAN TERMINATION RESISTOR
-
Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.
-
Is the resistance between 108 and 132 ohms?
Yes
GO to U6.
No
GO to U9.
-------------------------------------------------
U6 CHECK THE HS-CAN TERMINATION RESISTOR WITH THE PCM DISCONNECTED