Explorer AWD V8-4.6L (2010)
Throttle Body: Service and Repair
Throttle Body
Removal and Installation
1. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to Fuel Delivery and Air Induction.
2. Disconnect the electronic throttle control electrical connector.
3. Disconnect the Throttle Position (TP) sensor electrical connector.
4. Remove the 4 bolts, the Throttle Body (TB) and the TB gasket. Discard the gasket.
-
To install, tighten to 10 Nm (89 lb-in).
5. To install, reverse the removal procedure.