Explorer AWD V8-4.6L (2010)
2. Remove the 5 rear J-nuts and install new.
3. Position Safety Canopy(R) module by moving it rearward installing the rear bracket hook in the sheet metal.
4. Install the Safety Canopy(R) module B-pillar bracket hook in the sheet metal.
5. NOTE: Make sure all Safety Canopy(R) module bolt holes line up with all J-clips.
Install the Safety Canopy(R) module front 2 bolts with the forward most bolt first.
-
Tighten to 8 Nm (71 lb-in).
6. Install the Safety Canopy(R) module B-pillar bolt.
-
Tighten to 8 Nm (71 lb-in).
7. Install the 3 C-pillar Safety Canopy(R) module bolts.
-
Tighten to 8 Nm (71 lb-in).
8. Install the 2 Safety Canopy(R) module rear bracket bolts.
-
Tighten to 8 Nm (71 lb-in).
9. Attach the 3 Safety Canopy(R) module front tether pin-type retainers to the A-pillar.
10. NOTE: Make sure the Safety Canopy(R) module front tether bracket locator tab is correctly installed in the A-pillar sheet metal.
Install the Safety Canopy(R) module front tether bracket and bolt.
-
Tighten to 8 Nm (71 lb-in).
Vehicles with entertainment system
11. NOTE: Make sure to route the entertainment system wiring as noted during removal.
