Explorer Sport 2WD V6-245 4.0L SOHC VIN K SFI (2001)
4. Remove the rear door latch screws.
-
Discard the screws.
5. If equipped, remove the rear door lock actuator rivets.
-
Disengage the wiring harness locator.
6. If equipped, disconnect the rear door lock actuator electrical connector.
7. Remove the rear door latch.
1
Disconnect the door ajar switch electrical connector.
2
Disconnect the ground wire.
8. Disconnect the rear door latch actuating rods.
1
Disconnect the interior door handle actuating rod.
2
If equipped, remove the door lock actuator.
INSTALLATION
1. To install, reverse the removal procedure.
-
Use the special tool to install the rivets.
-
If necessary, use Multi-Purpose Grease Spray F5AZ-19G209-AA or equivalent meeting Ford specification ESR-M1C159-A to lubricate the
latches.