Explorer Sport 2WD V6-245 4.0L SOHC VIN K SFI (2001)
Wiring Harness: Service and Repair
Internal Harness Service
Removal
1. NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms can occur while the vehicle relearns its
adaptive strategy. The customer needs to be notified that they may experience slightly different upshifts either soft or firm and this is a temporary
condition and will eventually return to normal operating condition.
Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. Disconnect vehicle harness from transmission case (16 pin) connector.
4. Drain the transmission fluid.
5. NOTE: The main control assembly does not need to be removed.
Remove the transmission fluid filter.
1. Remove the transmission fluid filter screw.
2. Remove the transmission fluid filter.
6. Remove main control valve body wire loom.
^
Carefully lift up on wire loom guide and protector and disengage the retaining pins from the solenoid clamps.