Explorer Sport 2WD V6-4.0L VIN E (2002)
NOTE: Make sure the ends of the swing rods are positioned beneath the listing wires at the rear of the seat cushion foam.
2
Install the hog rings.
4. Invert the seat cushion trim cover.
5. Connect the seat cushion trim cover J-clips.
6. Install the seat cushion.
7. Reactivate the supplemental restraint system (SRS).
WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS, NOTES, AND
INSTRUCTIONS IN THE SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEACTIVATION/REACTIVATION PROCEDURE.
8. With all the restraint system diagnostic tools removed, prove out the supplemental restraint system (SRS).
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
THE VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF
VEHICLE SAFETY STANDARDS.
Without Side Air Bag
DISASSEMBLY
1. Remove the seat cushion.
2. Disconnect the seat backrest recliner actuator.
1
Remove the screws.
2
Disconnect the seat backrest recliner actuator.