Explorer Sport 2WD V6-4.0L VIN E (2002)
Brake Shoe: Adjustments
Brake Shoe Adjustment - Drums Removed
Brake Shoe Adjustment-Brake Drums Removed
Special Tools
Special Tool(s)
WARNING: Asbestos fiber dust can be present on brake and clutch assemblies and is hazardous to health if inhaled.
Brake and clutch assemblies must be cleaned using a vacuum cleaner recommended for use with asbestos fibers, such as a
Brake/Clutch/Service Vacuum. The bag must be labeled per OSHA instructions, sealed, and the trash hauler notified as to the bag's contents.
If a vacuum suitable for asbestos is not available, cleaning must be done wet. If dust generation is still possible, technicians must wear
government-approved toxic dust purifying respirators.
The Occupational Safety And Health Act (OSHA) requires areas where asbestos dust generation is possible to be isolated and posted with warning
signs. Only technicians performing brake or clutch repair are to be present in the area.
NOTE: After adjusting the rear brake shoes and linings check the parking brake for correct operation. Make sure the parking brake cable equalizer
operates freely.
1. Measure the brake drum inside diameter.
^
Use a brake adjustment gauge.
2. Adjust the rear brake shoes and linings.
^
Rotate the brake adjuster screw until the rear brake shoes and linings touch the tool.