Explorer Sport 2WD V6-4.0L VIN E (2002)
Wheel Fastener: Service and Repair
Front
Wheel Studs
Removal
1. Remove the wheel and tire assembly.
2. CAUTION: When removing the disc brake caliper, never allow it to hang from the brake hose. Provide a suitable support.
Remove the brake caliper and anchor plate as an assembly.
3. Remove the brake disc and hub as follows:
1
Remove the hub grease cap.
2
Remove the cotter pin.
3
Remove the nut retainer.
4
Remove the spindle nut.
5
Remove the front wheel outer bearing retainer washer.
6
Remove the outer front wheel bearing.
7
Remove the brake disc and hub.
4. CAUTION: Place shop towels between the pry bars and the brake disc to prevent damage to the disc surface.
Using two pry bars, remove the ABS sensor ring.
-
Discard the ABS sensor ring.
5. Using a suitable press, remove the wheel stud from the brake disc and hub.
Installation