Explorer Sport 2WD V6-4.0L VIN E (2002)
11. Disconnect the solenoid electrical connectors.
1
Disconnect shift solenoids SSB and SSD electrical connectors.
2
Disconnect the Torque Converter Clutch (TCC) solenoid electrical connector.
3
Disconnect the Electronic Pressure Control (EPC) solenoid electrical connector.
12. CAUTION: The TCC solenoid and converter modulator valve can pop out of their bore. This may damage the solenoid or converter modulator
valve.
Remove the EPC, SSB, and SSD solenoids.
1
Remove the wire harness.
2
Remove the solenoid clamp screws.
3
Remove the solenoid clamp.
4
Remove the EPC, SSB and SSD solenoids.
13. CAUTION: Do not pry on the other wires or damage to the connector case surface can result.
Disconnect the Turbine Shaft Speed (TSS) sensor electrical connector from the transmission case (16-pin) electrical connector.
1
Disconnect the TSS sensor electrical connector.
2
Remove the TSS sensor wire locator