Explorer Sport 2WD V6-4.0L VIN E (2002)
Install the manual valve inner lever nut.
3. Rotate the manual lever into the NEUTRAL position, and install the manual valve detent spring.
4. Clean the extension housing and install a new extension housing gasket. Make sure that the parking pawl, spring and shaft is correctly installed.
5. CAUTION: Make sure the parking lever actuating rod is correctly seated into the case parking rod guide cup.
Install the extension housing.
1
Position the extension housing.
2
Install the extension housing screws.
3
Install the extension housing stud.
6. If equipped, install the transfer case.
7. NOTE: Align the driveshaft with the marks made during removal to make sure balance is correct.
Install the rear driveshaft bolts.