Explorer Sport 2WD V6-4.0L VIN E (2002)
-
If the preload recorded prior to disassembly is lower than the specification for used bearings, then tighten the nut to specification. If the
preload recorded prior to disassembly is higher than the specification for used bearings, then tighten the nut to the original reading as recorded.
8. CAUTION: Align the Index-marks.
Install the four bolts.
9. CAUTION: The driveshaft centering socket yoke fits tightly on the rear axle pinion flange pilot. To ensure that the yoke seats squarely on the
flange, tighten the bolts evenly in a cross pattern as shown.
Tighten to specification.
10. Install the brake system.
11. Install the rear wheel and tire assemblies.
