Explorer Sport 2WD V6-4.0L VIN E (2002)
6. NOTE: Do not rotate the driveshaft while removing.
Lower the driveshaft and remove the slip yoke from the transmission output shaft.
7. Index-mark the transmission output shaft to the previously marked transmission extension housing.
8. CAUTION: If new bolts to retain the driveshaft to the axle are not available, coat the threads of the original bolts with Threadlock and Sealer
EOAZ-19554-AA or equivalent meeting Ford specifications.
CAUTION: The driveshaft flange fits tightly on the rear axle pinion flange pilot. To make sure that the driveshaft flange seats squarely on the
pinion flange, tighten the bolts evenly in a cross pattern as shown.
CAUTION: Make sure all index marks are aligned.
To install, reverse the removal procedure.