Explorer Sport 2WD V6-4.0L VIN E (2002)
2. Install the transmission mount.
1
Position the exhaust bracket.
2
Install the bolts.
3. Position the crossmember and install the six bolts and nuts.
4. Remove High-Lift Transmission Jack.
5. Install the nuts.
6. Install the transfer case, if equipped.
7. NOTE: To maintain initial driveshaft balance, align the index marks on the driveshaft and the rear axle pinion flange made during removal.
Install the rear driveshaft.
8. Install the drain plug.
9. Refill the transmission with the specified amount of fluid.
-
Use MERCON Multipurpose Automatic Transmission Fluid XT-2-QDX or equivalent meeting Ford specification MERCON.
10. Lower the vehicle.
