Explorer Sport Trac 2WD V6-245 4.0L SOHC VIN K SFI (2001)
24. Install the lower steering column opening finish panel.
1
Position the lower steering column opening finish panel to the I/P and push in at the top, seating the retaining clips.
2
Install the screws.
25. Position the hood release handle and install the screws.
26. Remove the restraint system diagnostic tool from the vehicle harness side of the passenger air bag electrical connector.
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF
VEHICLE SAFETY STANDARDS.
27. Install the passenger air bag module.
28. Connect the battery ground cable.
29. With all the diagnostic tools removed, prove out the air bag system.
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF
VEHICLE SAFETY STANDARDS.
30. Check the restraint system for correct operation.
Without Side Air Bag
REMOVAL
1. Remove the seat.
2. Remove the seat track.