Explorer Sport Trac 2WD V6-245 4.0L SOHC VIN K SFI (2001)
1. Install the safety belt buckle onto the safety belt buckle support assembly.
1
Position the safety belt buckle onto the slide bar.
2
Using the special tool, install the safety belt buckle bolt.
3
Remove the safety belt buckle support assembly from the vise.
2. Install the safety belt buckle support assembly onto the seat.
1
Position the safety belt buckle support assembly to the seat.
2
Install the nut and bolt.
3. Position the driver seat into the vehicle. Install and hand tighten the four seat track-to-floor bolts.
CAUTION: Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle can result
in damaged components.
4. Remove the restraint system diagnostic tool from the driver seat side air bag floor electrical connector.
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE CAN RESULT IN INJURY AND POSSIBLE VIOLATION OF VEHICLE
SAFETY STANDARDS.