Explorer Sport Trac 2WD V6-245 4.0L SOHC VIN K SFI (2001)
5. CAUTION:
^
Do not under any circumstance loosen the nut to reduce preload. If it is necessary to reduce preload, install a new collapsible spacer and nut.
^
Remove the special tool while taking preload readings with the Nm (inch-pound) torque wrench.
Use the special tool to hold the pinion flange while tightening the nut.
^
Rotate the pinion occasionally to make sure the differential pinion bearings seat correctly. Take frequent differential pinion bearing preload
readings by rotating the pinion with a Nm (inch-pound) torque wrench.
^
If the preload recorded prior to disassembly is lower than the specification for used bearings, then tighten the nut to specification. If the
preload recorded prior to disassembly is higher than the specification for used bearings, then tighten the nut to the original reading as recorded.
6. CAUTION: Align the Index-marks.
Install the four bolts.
7. CAUTION: The driveshaft centering socket yoke fits tightly on the rear axle pinion flange pilot. To ensure that the yoke seats squarely on the
flange, tighten the bolts evenly in a cross pattern as shown.
Tighten to specification.
8. Install the bake system.
9. Install the rear wheel and tire assemblies.