Explorer Sport Trac 2WD V6-4.0L (2009)
Trim Panel: Service and Repair
B-Pillar Upper Trim Panel
B-Pillar Upper Trim Panel
Removal and Installation
1. Remove the B-pillar lower trim panel. For additional information, refer to B-Pillar Lower Trim Panel See: B-Pillar Lower Trim Panel.
2. Remove the D-ring safety belt anchor bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
3. Position the door opening weatherstrip aside.
4. Remove the B-pillar upper trim panel retaining clip from the lower right corner of the panel.
5. Remove the B-pillar upper trim panel retaining clip from the upper left of the panel.
6. To install, reverse the removal procedure.
-
Be sure the hole on the back of the B-pillar upper trim panel is seated over the safety belt D-ring bolt.