Explorer Sport Trac 2WD V6-4.0L (2009)
5. Remove the 2 backrest support panel lower screws and detach the latch cable. Position the cable out from between the backrest frame and backrest
support panel.
6. Remove the 4 backrest pivot bolts.
7. Remove the 40 percent backrest.
Installation
1. Position the backrest to the latch. The cable is to be routed in front of the spring.
2. NOTE: When installing the backrest to the cushion, make sure the latch cover does not come in contact with the latch cable conduit or end fitting.
The cable is to move freely after assembly.
The cable is to pass between the backrest frame and the backrest support at the 2 points shown.
3. Install the 4 backrest pivot bolts.
-
Tighten to 40 Nm (30 lb-ft).
4. Install the 2 backrest support panel lower screws.
5. NOTICE: When installing the backrest to the cushion, make sure the latch cover does not come in contact with the latch cable conduit or
end fitting.
Position the 2 covers and install the 4 screws. Attach the material attachments to both of the latch covers.
6. Roll the seat backrest trim cover and foam pad back down into position.
7. Position the trim cover and install staples in the backrest support panel.
8. Attach the seat backrest J-clip.
Seat Backrest - Second Row, 60 Percent, Bench
Seat Backrest - Second Row, 60 Percent, Bench
Removal
All vehicles
1. Remove the second row 60 percent seat of the 60/40 bench seat. For additional information, refer to Seat - Second Row, Sport Trac See: Service
and Repair/Second Row Seating/Seat - Second Row or Seat - Second Row, Explorer, 60/40 Bench .
Sport Trac vehicles
2. Remove the safety belt guide cover in the following sequence.
