Explorer Sport Trac 2WD V6-4.0L (2009)
1. Tighten the Camshaft Sprocket Holding Tool top 2 clamp bolts to 10 Nm (89 lb-in).
2. Tighten the LH camshaft bolt to 85 Nm (63 lb-ft).
25. Remove the Timing Chain Tensioner.
26. NOTE: Install a new washer on the tensioner.
Install the LH hydraulic timing chain tensioner.
-
Tighten to 44 Nm (32 lb-ft).
27. Remove the Camshaft Holding Tool, the Adapter for 303-577, the Camshaft Sprocket Holding Tool and the Adapter for 303-564 from the LH
cylinder head.
28. Remove the Crankshaft TDC Timing Tool.
29. Position the battery cable bracket and install the nut.
-
Tighten to 20 Nm (177 lb-in).
30. If necessary, position the A/C compressor and power steering pump bracket and install the 4 bolts.
-
Tighten to 42 Nm (31 lb-ft).