Explorer Sport Trac 2WD V6-4.0L (2009)
3. Remove the accessory drive belt.
4. NOTE: This bolt is torque-to-yield and cannot be reused.
Using the Strap Wrench to hold the crankshaft pulley, remove the bolt.
5. NOTE: If the pulley bolt is not installed, the tool will bottom out before the pulley is off.
Install the crankshaft pulley bolt 2 to 3 turns. Using the 2 Crankshaft Vibration Damper Removers and the two 8-mm bolts, remove the crankshaft
pulley.
-
Discard the crankshaft pulley bolt.
Installation
1. Using the Crankshaft Vibration Damper Installer, install the crankshaft pulley.
2. Using the Strap Wrench to hold the crankshaft pulley, install a new crankshaft pulley bolt. Tighten the bolt in 2 stages.
-
Stage 1: Tighten to 55 Nm (41 lb-ft).
-
Stage 2: Tighten an additional 85 degrees.
3. Install the accessory drive belt.
4. Install the fan shroud.